Springsol® process is one of a wide range of solutions within the Deep Soil Mixing family. It uses a fixed or opening tool to construct columns using a small diameter drilling rig.

The process was initially developed in order to reinforce railway platforms without removing the tracks, while respecting certain requirements:

• Work with low clearance (beneath overhead lines),

• Drilling between railway sleepers,

• Protection of ballast, particularly with regard to cementing,

• Need for minimal traffic disruption.

Since then, the process has been applied to a wide variety of soil improvement works. As well as the reinforcement of railway platforms, the process was used for ground improvement works under paving, concrete slabs and footings, embankment stabilisation and in-situ soil remediation.

Like other soil-mixing elements, Springsol® columns behave as semi-rigid inclusions, stiffer than the non-treated soil, but softer and less rigid than concrete.

Depending on the presence of existing elements (paving, foundations, rocks, etc.), the soil is can be treated only at depth or directly from the surface. To do this, two types of tools can be used:

• An opening tool
  • Folded diameter: 160mm or 225mm
  • Open diameter: 400mm/600mm or 800mm/900mm
  • Used for underpinning, and/or with limited headroom and/or in confined spaces.

• A fixed tool:
  • Diameter: 400mm, 600mm, 800mm, 900mm
  • Used when working with limited headroom and/or in confined spaces.

What are the advantages of this technique?

Implementation

When using an opening tool, the Springsol® process includes five phases:

• Preliminary installation of a casing (or preliminary coring),
• Drilling with the tool, which opens once the bottom of the casing/coring has been reached,
• Incorporation of grout at low pressure and mixing while drilling
• Additional mixing while the tool is progressively extracted,
• The tool folds up again for extraction via the casing/coring.

When used with a fixed tool, the Springsol® process simply involves low-pressure incorporation of grout and mixing during drilling, along with further mixing during extraction.

Did you know?

• Small diameter augers allow the columns to be constructed at any angle, from vertical to horizontal.
• In some situations, the casing can be installed during the drilling phase with the opening tool.
• This technique has also been patented for the installation of anchors, particularly in clay.

Here are a few of the projects carried out using the Springsol® process:

The Deep Soil Mixing family of techniques also includes these processes in addition to Springsol®:

• The Colmix® process
• The Geomix® process
• The Trenchmix® process